首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   9075篇
  免费   1289篇
  国内免费   1032篇
化学   3254篇
晶体学   99篇
力学   1113篇
综合类   139篇
数学   1746篇
物理学   5045篇
  2024年   14篇
  2023年   80篇
  2022年   123篇
  2021年   199篇
  2020年   192篇
  2019年   203篇
  2018年   189篇
  2017年   300篇
  2016年   367篇
  2015年   313篇
  2014年   475篇
  2013年   684篇
  2012年   518篇
  2011年   620篇
  2010年   492篇
  2009年   568篇
  2008年   590篇
  2007年   640篇
  2006年   511篇
  2005年   514篇
  2004年   457篇
  2003年   420篇
  2002年   389篇
  2001年   293篇
  2000年   289篇
  1999年   249篇
  1998年   194篇
  1997年   174篇
  1996年   143篇
  1995年   135篇
  1994年   136篇
  1993年   119篇
  1992年   88篇
  1991年   93篇
  1990年   68篇
  1989年   63篇
  1988年   54篇
  1987年   44篇
  1986年   42篇
  1985年   57篇
  1984年   39篇
  1983年   15篇
  1982年   52篇
  1981年   39篇
  1980年   30篇
  1979年   18篇
  1978年   19篇
  1977年   16篇
  1976年   25篇
  1973年   11篇
排序方式: 共有10000条查询结果,搜索用时 17 毫秒
1.
《Mendeleev Communications》2022,32(4):534-536
Correlation times and diffusion coefficients of water molecules were measured for the first time by 1H spin relaxation and pulsed field gradient NMR in Li+, Na+ and Cs+ ionic forms of Nafion 117 membrane. Hydration numbers of Li+, Na+ and Cs+ cations were calculated. It was shown that at high humidity macroscopic transfer is controlled by the local translational motion of water molecules.  相似文献   
2.
针对机油滤清器工作工况下进出口压差、机油滤层强度及导流桩高度等问题, 通过试验测试与仿真相结合, 对滤清器初步设计进行了评估及优化, 以确保滤清器在工作工况下进出口压降及滤层强度能满足要求. 首先进行滤层性能试验, 得到滤层的惯性阻力系数和黏性阻力系数; 再通过滤层多孔介质CFD分析, 对滤清器进出口压降进行分析计算. 结果表明: 在-18℃、25℃和70℃的工况下, 进出口压降都小于10kPa, 满足相关要求. 针对滤层的最大主应力超过其抗拉强度的问题, 通过CAE仿真分析, 优化滤层与导流桩间隙, 将滤层最大主应力由110.1MPa降至36.99MPa, 小于其抗拉强度42.8MPa.  相似文献   
3.
We studied the ring opening of propylene oxide (PO) by salen-M coordinated OH group [M = Al(III), Sc(III), Cr(III), Mn(III), Fe(III), Co(II), Co(III), Ni(II), Cu(II), Zn(II), Ru(III) and Rh(III)]. The results show that the ring-opening energy barriers for M(II) complexes are much lower than those with M(III) complexes in the gas phase, and the barriers correlate linearly with the negative charges on the OH group and the Fukui function condensed on the OH group. The nucleophilicity ordering in the gas phase can be rationalized by the ratio of formal positive charges/radius of M cations. Solvent effect greatly increases the barriers of M(II) complexes but slightly changes the results of M(III) ones, making the barriers similar. Analysis indicates that the reaction heats are linearly proportional to the reverse reaction barriers. The relationships established here can be used to estimate the ring-opening barriers and to screen epoxide ring-opening catalysts.  相似文献   
4.
本文采用关联分析方法研究了稳定温度分层湍流中的结构特性、输运特性,以及热量、动量逆梯度输运现象的尺度效应及其参数演化.首先采用大涡模拟方法对稳定分层湍流中的结构特性和输运特性进行了分析,将逆梯度输运发生的时间尺度作为已知条件,结合关联量分析方法在波数空间中的解析解,对逆梯度输运现象的尺度效应进行了分析研究.结果发现,稳定分层强度较大的流动中发生垂向热量及动量逆梯度输运现象,发生的结构尺度与关联分析所发现垂向热量、动量逆梯度输运的波数形成了呼应.随着分层强度增加,热量、动量的输运强度均受抑制,与逆梯度输运关联的流场结构尺度减小,同样的效应也发生在流场结构向下游演化的过程中.  相似文献   
5.
In the present work, the use of cylindrical turbulators in a double pipe heat exchanger has been investigated. Cylindrical fin type of turbulators has been placed circumferentially separated by 90° on the outer side of an inner pipe at a regular pitch. Experimental studies were undertaken for different air flow rates in a turbulent regime whose Reynolds number range between 2500 and 10000. Heat transfer characteristics like Nu and friction factor have been experimentally determined. Parametric studies were conducted by changing the pitch and also the orientation of the turbulators. Nu and friction factor were found to increase as the pitch is reduced. A model with alternatively changed orientation outperformed others by exhibiting highest Nu and reduced friction factor.  相似文献   
6.
飞行器液压导管受接头和卡箍等约束,在使用的振动环境中,会因弯曲应力而导致破裂,影响到飞行安全.本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究.首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上,得到了导管的最大拉应变-裂纹萌生寿命数据.然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命.最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数,使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度.  相似文献   
7.
本文以水作为理想流体,考虑到水头损失和孔口缩流效应,对小孔流速实验涉及的容器排水问题进行了系统的理论和实验研究.从理论上推导得出了圆柱形容器排水时间的解析解,分析了排水时间和自由液面速度、流量系数之间的规律,提出了排水时间的等效性.实验上,加工了底部开有不同小孔的大型圆柱形容器,测量了容器排水时间随液面高度的变化关系,借助实验结果计算了流量系数值,验证了容器排水时间的等效性关系,实验结果与理论计算符合较好.  相似文献   
8.
利用热丝化学气相沉积法(HFCVD)在碳化硅基底上制备金刚石薄膜,采用场发射扫描电子显微镜、拉曼光谱仪、原子力显微镜研究了在不同甲烷浓度条件下制备的金刚石薄膜表面形貌及物相组成,在干摩擦条件下通过往复式摩擦磨损实验测试并计算了已制备金刚石薄膜的摩擦系数和磨损率,结合物相分析及摩擦磨损实验结果分析了甲烷浓度的改变对金刚石薄膜摩擦磨损性能的影响。结果表明,由于甲烷气体含量的升高,金刚石薄膜结晶质量下降,薄膜由微米晶向纳米晶转变。摩擦磨损实验结果显示:3%甲烷浓度条件下制备的金刚石薄膜耐磨性较好,磨损率为2.2×10-7 mm3/mN;5%甲烷浓度条件下制备的金刚石薄膜摩擦系数最低(0.032),磨损率为5.7×10-7 mm3/mN,制备的金刚石薄膜的耐磨损性能相比于碳化硅基底(磨损率为9.89×10-5 mm3/mN)提升了两个数量级,显著提高了碳化硅基底的耐磨性。  相似文献   
9.
乔洋  张盛  刘少伟  王猛 《实验力学》2020,(2):287-299
裂纹前端的断裂过程区是引起岩石非线性断裂及尺寸效应的主要原因。利用数字图像相关技术对砂岩开展了三点弯曲梁实验,获得观测区域高精度的全场位移和应变数据,根据断裂韧带区域水平位移和水平应变的分布特征,结合裂尖岩石颗粒变化的微观分析,提出采用裂纹尖端水平位移波动性和水平应变突变性所得到的波动系数和水平应变突变值,确定断裂过程区形状和临界尺寸的方法。结果表明:砂岩断裂过程区的形状为不规则的狭长带状区域,断裂过程区的临界长度为11~13mm,临界宽度为1.58~2.36mm。断裂过程区区域内形变在趋向裂尖时呈指数增加,但其单位区域内的形变增量呈波动状态。该方法能够更加准确判断岩石断裂过程区的范围,有助于分析岩石的非线性断裂特性。  相似文献   
10.
A kinetic study of the reactions of potentially bioactive 2-amino-4-arylthiazoles with highly reactive 4,6-dinitrobenzofuroxan (DNBF) is reported herein in acetonitrile solution. The complexation reaction was followed by recording the UV–vis spectra with time at λmax = 482 nm. Electronic effects of substituents influencing the rate of reaction have been studied using structure-reactivity relationships. It is shown that the Hammett plot relative to the reaction of DNBF with 2-amino-4-(4-chlorophenyl)thiazole exhibit positive deviation from the log k1 versus σ correlation, while it showed excellent linear correlation in terms of Yukawa–Tsuno equation. It has be noticed that the nonlinear Hammett plot observed for 2-amino-4-(4-chlorophenyl) thiazole is not attributed to a change in rate-determining step but is due to nature of electronic effect of substituent caused by the resonance of stabilization of substrates. The second-order rate constant (k1) relating to the bond C–C and C-N forming step of the complexation processes of DNBF with 4-substituted-aminothiazoles and 2-amino-5-methyl-4-phenylthiazole, respectively, is fit into the linear relationship log k = sN (N + E), thereby permitting the assessment of the nucleophilicity parameter (N) of the 2-amino-4-arylthiazoles of the range (4.90 < N < 6.85). 2-amino-4-arylthiazoles is subsequently ranked by positioning its reactivity on the general nucleophilicity scale developed recently by Mayr and coworkers (2003) leading an interesting and a direct comparison over a large domain of π-, σ -, and n-nucleophiles. The global electrophilicity/nucleophilicity reactivity indexes of the 2-amino-4-arylthiazoles have been investigated by means of a density functional theory (DFT) method. .  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号